|
| Zenoah
260 Jug |
|
|
|
| Zenoah 231 Jug
|
 |
|
|
Zenoah Crank assembly |
 |
|
|
| Zenoah 260/231 Crankcase |
 |
Bearings and seals installed. If your engine needs a rebuild, this
is a very affordable and easy way. Add up the cost of bearings, seals,
and a gasket, this is the easy way..... |
|
|
Zenoah 260 Piston |
 |
|
|
Zenoah 231 Piston |
 |
|
|
Zenoah 260 piston ring |
 |
|
|
Zenoah 231 piston ring |
 |
|
|
Zenoah 260 Wrist pin |
 |
|
|
Zenoah 231 Wrist pin |
 |
|
|
Zenoah 260 top end |
 |
260 top end includes: Plug, cooling cap, fittings, o rings, cap screws,
jug, insulator block, insulator to jug gasket, and bolts.
A great price savings! |
|
|
Zenoah 260 top end |
 |
260 top end includes: all pictured
A great price savings! |
|
|
| Zenoah Recoil |
 |
|
|
|
| Zenoah Recoil Starter Kit |
 |
|
|
Champion spark plug |
 |
|
|
| Ignition coil |
 |
|
|
| Plug cap |
 |
|
|
| Plug cap spring |
 |
|
|
Source coil |
 |
|
|
Flywheel |
 |
|
|
| 260/231 cooling cap w/fittings
and Orings |
 |
|
|
| 260/231cooling cap fitting |
 |
|
|
| O-Rings for cooling cap |
 |
|
|
|
Rear seal (small) |
 |
|
|
Front seal (large) |
 |
|
|
Crank shaft bearing |
 |
|
|
Ceramic crank shaft bearings |
| Team FastEddy Ceramic engine bearing set. Used by several of the top
engine builders in the industry. A great value for top-notch ceramic bearings.
Includes Set of two (2) open crank ceramic high performance engine bearings.
440C stainless steel bearing material, ceramic Si3N4 (silicon nitride)
rolling element material. Rated to 35,000+ RPM. |
|
|
| Sealed shaft bearing |
 |
|
|
| Crank shim |
 |
Use this shim between the crank and the bearings to lower end play
(crank moving front to back)
Note: Some end play is necessary.
|
|
|
| Wrist pin retainer
clip |
 |
|
|
Connecting rod bearing |
 |
|
|
| Wrist Pin Bearing Spacer |
 |
|
|
Crankshaft key |
 |
|
|
Plate mount |
 |
|
|
| Starter dog |
 |
|
|
Insulator block |
 |
|
|
| Walbro WT644 carb |
 |
|
|
| Primer
bulb for Walbro carbs |
 |
|
|
| Walbro carb rebuild kit |
 |
|
|
| Walbro diaphragm |
 |
|
|
Plastic Velocity stack |
 |
|
|
| Gasket
- 260/231 cylinder base |
 |
|
|
Gasket - jug/intake insulator |
 |
| Note: Gasket may be blue or black. |
|
|
Gasket - carb/ins |
 |
|
|
Gasket - Crankcase |
 |
|
|
Gasket - Exhaust |
 |
|
|
Zenoah Tool |
 |
|
|
Case bearing retainer clip |
 |
|
|
Bolts |
 |
These are removed from a new engine and contains all but: carb and
case |
|
|
Replacement cord |
 |
|
|
| |
| |
| |
| |